Bondtech upgrade voltage setup

CV-Gate
Posts: 13
Joined: Fri Aug 03, 2018 9:28 pm

Bondtech upgrade voltage setup

Postby CV-Gate » Sun Sep 23, 2018 5:25 pm

Hello, after installing my Bondtech extruder, I have successfully adjusted to 0.5 v the top left trimmer. The next step is "do the same with the second motor". As I have a dual extruder, I must do it but the instructions are not very helpful. Could anybody tell me what is the trimmer for this? The one bellow? The first one of the left-sided trimmers? Do I have to adjust only one trimmer for every motor? All of them?

Thanks!

Evan
Posts: 127
Joined: Mon Mar 21, 2016 3:07 pm

Re: Bondtech upgrade voltage setup

Postby Evan » Sun Sep 23, 2018 9:59 pm

It's the one to the left of it, closest to the edge. You only have to adjust those 2 stepper drivers

CV-Gate
Posts: 13
Joined: Fri Aug 03, 2018 9:28 pm

Re: Bondtech upgrade voltage setup

Postby CV-Gate » Sun Sep 23, 2018 10:31 pm

Sorry but I think I don't have any other to the left. I have some below, like in this picture.

Image

Evan
Posts: 127
Joined: Mon Mar 21, 2016 3:07 pm

Re: Bondtech upgrade voltage setup

Postby Evan » Mon Sep 24, 2018 2:13 pm

So it's the one that you have your probe on and the one right next to it. If you look at the edge of the board where the white plugs with the black wires are, they're labeled E0 and E1 motor.

CV-Gate
Posts: 13
Joined: Fri Aug 03, 2018 9:28 pm

Re: Bondtech upgrade voltage setup

Postby CV-Gate » Mon Sep 24, 2018 2:34 pm

So it's the one below, right?
Thanks a lot for your answer.

Evan
Posts: 127
Joined: Mon Mar 21, 2016 3:07 pm

Re: Bondtech upgrade voltage setup

Postby Evan » Mon Sep 24, 2018 2:44 pm

Yes that's correct


Return to “N Series”

Who is online

Users browsing this forum: mb300sd and 1 guest