Im about half way intalling a bond tech. Ive removed the old extruder, have put the version one shim on the bond tech and lowered into place.
Putting the rear screws in only one screw just spins loosely its not catching the screw thread. Thing is when I swapped them it was the same screw in the new hole that was loose whilst the other one swapped over fine.... This indicates its the screw not the hole thats the problem.
Under the magnifying glass both look the same and there is definetely a screw thread on it. Cant seem to find spares anywhere.
How important is the second rear screw holding the extruder. ?
Don't want anything going wrong as only just got it serviced.
Need to finish installing the bondtech
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest