Add a "Global Speed Multiplier" (%) in the setting, by which all speed settings will be multiplied by.
Ideally expose this setting in the "Basic/General" settings as well for easier change.
I very often find myself want to print with exactly the same profile, except from tuning the speed up or down a bit. To do this right now, we have to go into advanced settings, on every relevant tab where some specific speed setting exists and change all of them one by one.
A global speed multiplier will makes this so much easier.
Thank you for creating such a great slicer!
Please post your suggestions for software changes here
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests