Preset temperatures for preheat

Please post your suggestions for software changes here
lazdee
Posts: 7
Joined: Mon Mar 05, 2018 7:56 pm

Preset temperatures for preheat

Postby lazdee » Mon Mar 19, 2018 7:17 pm

It would be a big convenience if there was a selection to preheat the bed and nozzles in a single step. A preheat temperature could be entered once and stored for the bed and each nozzle then use a PREHEAT selection to preheat to the same temperatures every time.

User avatar
Vicky@Raise3D
Posts: 3618
Joined: Fri Mar 25, 2016 3:54 am

Re: Preset temperatures for preheat

Postby Vicky@Raise3D » Tue Mar 20, 2018 7:27 am

Notes taken.

jon_bondy
Posts: 102
Joined: Fri Jan 26, 2018 6:24 pm

Re: Preset temperatures for preheat

Postby jon_bondy » Tue Mar 20, 2018 1:06 pm

It would also be nice if the Load/Unload temperatures were remembered after a power cycle. They seem to always be 215 after the printer comes on, even if they were set otherwise before.

User avatar
Vicky@Raise3D
Posts: 3618
Joined: Fri Mar 25, 2016 3:54 am

Re: Preset temperatures for preheat

Postby Vicky@Raise3D » Wed Mar 21, 2018 5:28 am

jon_bondy wrote:It would also be nice if the Load/Unload temperatures were remembered after a power cycle. They seem to always be 215 after the printer comes on, even if they were set otherwise before.


Noted.


Return to “Software”

Who is online

Users browsing this forum: No registered users and 2 guests