Please post your suggestions for software changes here
4 posts • Page 1 of 1
It would be a big convenience if there was a selection to preheat the bed and nozzles in a single step. A preheat temperature could be entered once and stored for the bed and each nozzle then use a PREHEAT selection to preheat to the same temperatures every time.
jon_bondy wrote:It would also be nice if the Load/Unload temperatures were remembered after a power cycle. They seem to always be 215 after the printer comes on, even if they were set otherwise before.
Who is online
Users browsing this forum: No registered users and 1 guest