This request is to be able to build different hotend temperatures at set layer levels into a table like the fan speed table (if not just using the same table as the fan speed table).
There is room on the Cooling tab to add another Dialog for Temperature Control. You could insert parameters for Bed, Left and Right temperatures at different layers when it is enabled.
If someone wanted the bed at different starting temperature and then to change it layer. They could
If they wanted to print out a temperature tower, they could set the layer parameters here.
Please post your suggestions for software changes here
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest