Resume does not turn on cooling fan

[gizmo91]

Have a third fan hooked up to the 'cooling' fan (third connector in from left - next to always on fans), however had a power failure this morning, R3D N2 did a great job resuming the print, however I noticed the cooling fan was no longer 'on'. Paused it an move the fan over to one of the always on as a temp fix.

Fix the resume functionality to include the 'cooling fan' status, also implement the fourth fan (and include in ideamaker to be able to activate) that has a connection but no way to control (turn on/off).

BTW - it was 13 hours into 30 hour print, the resume function is GOLD! Love the R3D for that feature.

[Vicky@Raise3D]

Would you like to advise which version of touchscreen firmware you are using?

[gizmo91]

version 0.7.0.221?

[Vicky@Raise3D]

We should have fixed this in 0.8.0 and the latest version is 0.9.2.
You can download from our website and test.

[gizmo91]

Glad to see its fixed.

I'm still afraid to update, when I first got my printer I immediately updated the firmware to 1.1.3 and the hell began, after about a week downgraded back to 1.1.1 (which the machine came with) and its worked great since......so if not broke don't fix

Where can I find old firmware files? In case I need to go back to the one I have? How about old IdeaMaker versions (troubleshooting another new issue)

[Vicky@Raise3D]

All the firmwares are in our download center. The official motion board firmware is still 1.1.1.
But the touchscreen firmware is keeping on updating. And we have put the rollback versions 0.7.2, 0.8.0 and 0.9.0 in download center in case you meet any bug after upgrade the firmware.
https://www.raise3d.com/pages/download

Which problems have you meet with the new version of ideaMaker? If you didn't delete it, the installation package should still save in download folders in your computer.