Please DONT turn off extruder heater after loading

Please post your suggestions for software changes here
User avatar
walshlg
Posts: 1309
Joined: Wed Mar 23, 2016 12:01 pm

Please DONT turn off extruder heater after loading

Postby walshlg » Sun Jun 11, 2017 10:25 pm

Its us a bit of a pain when i preheat the bed and nozzle, load the filament, come back in 10 min when the bed has stabilized and find the nozzle is cold again.

I just find it illogical to turn off the heat when loading filament so I never remember.

User avatar
Vicky@Raise3D
Posts: 2279
Joined: Fri Mar 25, 2016 3:54 am

Re: Please DONT turn off extruder heater after loading

Postby Vicky@Raise3D » Mon Jun 12, 2017 1:36 am

We will release a new version of touchscreen firmware very soon.
Which has been newly added an option for you to choose whether you want to close or keep heating after loading.


Return to “Software”

Who is online

Users browsing this forum: No registered users and 1 guest