M2000

Please post your suggestions for software changes here
doska
Posts: 1
Joined: Thu Nov 01, 2018 6:37 am

M2000

Postby doska » Thu Nov 15, 2018 2:34 pm

Pro2
ideaMaker 3.3.0
0-0-66
1.1.0.1021

M2000 does not work.
When i put it in code manually, or via ideaMaker, for example at 0.6mm (0.3 layer height) it pauses, then i hit hesume and it pauses again. And again, and again...

None of G-codes for pause that i found doen not work. So, how i can see, M2000 is the only option. And it does not work.
What should i do? I need this pause.

User avatar
Vicky@Raise3D
Posts: 4530
Joined: Fri Mar 25, 2016 3:54 am

Re: M2000

Postby Vicky@Raise3D » Wed Nov 21, 2018 8:13 pm

Thanks for your report.
Did you enable User FastPause under the 2rd page of Advanced Settings on screen? If so, please disable it and see whether M2000 can work properly or not.


Return to “Software”

Who is online

Users browsing this forum: No registered users and 1 guest