Page 1 of 1

DYZE Filament Sentinel

Posted: Mon Sep 11, 2017 2:22 pm
by hovig_p
Hi Raise3D

Recently I sent an e-mail to Dyze Design asking them about the DYZE Filament Sentinel and if it works on Raise3D Products.

They responded and said they are working with a few folks at Raise3D to make this happen. Just checking to see if this is a possibility.

This tool will detect your filament and pause your print if it runs out which has happened to me and I'm sure others a few times.

Here's a link for everyone to check it out. ... entinel-2/

Re: DYZE Filament Sentinel

Posted: Mon Sep 11, 2017 4:00 pm
by Vicky@Raise3D
As I known, our R&D team should be currently testing our filament monitor sample. Haven't heard any news about cooperation with other brand's filament sensor yet. Will double check with our R&D team.

Re: DYZE Filament Sentinel

Posted: Tue Sep 12, 2017 7:18 pm
by hovig_p
OH! So you guys have one in the works? AWESOME! :-)

Re: DYZE Filament Sentinel

Posted: Thu Sep 14, 2017 10:37 am
by Vicky@Raise3D
Not such soon to be released to public, but already on testing now.

Re: DYZE Filament Sentinel

Posted: Thu Sep 28, 2017 2:12 pm
by thyshallsmite
can't wait for this to be released, have 2 N2s that need this badly

Re: DYZE Filament Sentinel

Posted: Sun Dec 10, 2017 4:44 pm
by AJM
Another approach is to use the guts from a laser mouse. No physical contact required. It even works with transparent filament. That also provides an option to plug it into Touch Controller's USB port rather than using the motion controller, which means it is easily relocatable to the top of the machine where the camera USB port already exists. Output for multiple detectors can simply be combined and go through the same USB port as well.