HOTEND set screws

Please post your suggestions for hardware features
User avatar
Posts: 1272
Joined: Wed Mar 23, 2016 12:01 pm

HOTEND set screws

Postby walshlg » Mon Jul 17, 2017 12:52 am

I had to replace my thermocouples and was extremely frustrated -> they are held in by short little m1.5 set screws. Into Aluminum! They were, predictably, bound in and could only be removed with a brand new Allen wrench.

PLEASE redesign the hot end block to use bigger screws. Personally, I favor M3 cap screws (there is no good reason to use set screws other than aesthetics) but at least go to a minimum of M2.5. The M1.5 will always bind and quickly destroy most Allen wrenches and lead to more broken isolation tubes.

Return to “Hardware”

Who is online

Users browsing this forum: No registered users and 1 guest