Boards
-
- Forum
- Statistics
- Last post
-
-
General
Thoughts about Raise3D, 3D printing and making in general. -
Topics: 499
Posts: 4377 -
Last post
Re: What are your current pro…
by Mecha_Monster View the latest post
Sun Aug 20, 2017 4:09 am
-
-
-
Printing Software
Discussions about ideaMaker and other printing software. -
Topics: 322
Posts: 2485 -
Last post
Re: Travel moves through open…
by Jetguy View the latest post
Mon Aug 21, 2017 12:52 am
-
-
-
Hardware
Topics around mechanical design, controller and electronics. Mods & hacks welcome. -
Topics: 589
Posts: 6373 -
Last post
Re: Power back up for raise 3…
by bellatrixzen View the latest post
Sun Aug 20, 2017 2:09 pm
-
-
-
User's Gallery
Show off your prints, mods, etc. -
Topics: 116
Posts: 907 -
Last post
Re: Single extruder multiple …
by bellatrixzen View the latest post
Thu Aug 17, 2017 8:37 pm
-
-
-
Feature requests, ideas, wishes
Raise3D is always hearing. If you have a feature requested related to our product, or if you have new ideas that need attention from the community, please post here.
Subforums: Hardware, Software -
Topics: 177
Posts: 1108 -
Last post
Re: You like to change a slic…
by Brandon View the latest post
Mon Aug 21, 2017 2:44 pm
-
-
-
Others
Any topics that don't fall into above categories. Please note that your thread may be moved to other discussion boards. -
Topics: 95
Posts: 882 -
Last post
Re: Filament stuck inside
by sgeolog View the latest post
Fri Aug 18, 2017 1:40 pm
-
-
-
Printing Settings
Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here. -
Topics: 88
Posts: 498 -
Last post
Re: Standard R3D PLA
by chengl03 View the latest post
Sun Aug 20, 2017 10:04 pm
-
-
-
Software
New section for each individual opensource software discussion.
Subforums: ideaMaker, Simplify3D, Cura -
Topics: 9
Posts: 53 -
Last post
Re: Custom G Code parameters
by Vicky@Raise3D View the latest post
Fri Aug 04, 2017 7:55 am
-
Who is online
Users browsing this forum: No registered users and 1 guest