Search found 7 matches
Search found 7 matches • Page 1 of 1
Just went through the same experience on a dual extruder N2. Fan stopped on the primary fan overnight and printed air most of the night. Filament appears to have softened and drive gear ended up breaking filament. Filament was free to move but the filament had a clear break at the drive gear and fil...
- Mon Mar 19, 2018 7:17 pm
- Forum: Software
- Topic: Preset temperatures for preheat
- Replies: 3
- Views: 206
It would be a big convenience if there was a selection to preheat the bed and nozzles in a single step. A preheat temperature could be entered once and stored for the bed and each nozzle then use a PREHEAT selection to preheat to the same temperatures every time.
- Tue Mar 13, 2018 4:47 pm
- Forum: Feature requests, ideas, wishes
- Topic: N2 Cover
- Replies: 21
- Views: 3121
Here's our solution -- add a 3D corner to hold the lid and 1/8in clear polycarbonate. Corner clips onto the lip at the top of the enclosure and holds the polycarbonate in slots (add a little glue). Polycarbonate cut to 20-1/4in x 4-3/16in and 18-15/16in x 4-3/16in, two of each. Attached the STL file...
- Wed Mar 07, 2018 4:28 pm
- Forum: Hardware
- Topic: Ethernet disconnects after long idle periods
- Replies: 3
- Views: 225
I use static network settings and turn DHCP off. I notice after an overnight build, the ethernet connection is not accessible in the morning. To reconnect, I recall the ethernet screen on the printer and press OK. The printer reconnects to its IP address and all is well. Does the ethernet connection...
I just found a workaround using WinSCP. - Sort by name by clicking on the NAME column - Select all by CNTL-A - Right click and select FILE CUSTOM COMMANDS - Select TOUCH This command refreshes the CHANGED DATE/TIME on all files and indirectly causes the files to be date/timestamp in name order. The ...