Search found 5 matches

by kazaar13
Mon Feb 19, 2018 3:17 pm
Forum: Printing Settings
Topic: Cannot get a good print
Replies: 9
Views: 191

Re: Cannot get a good print

Was hoping the speed and dual extrusion would speed up the process. Alas it must just be slow and steady. Have the slow trying to find the steady. If your parts are less than 25mm wide you might be able to run both barrels at the same time creating duplicate parts. I've never tried that. You need t...
by kazaar13
Mon Feb 19, 2018 6:58 am
Forum: Printing Settings
Topic: Cannot get a good print
Replies: 9
Views: 191

Re: Cannot get a good print

On top of all the above comments, have patience. I've been at this for 2 years now and I'm still getting better with every step. It's not a plug-n-play process, and it will take time for you to figure out what works best for you. Also, regarding speed - everything is a trade-off. I sometimes print ...
by kazaar13
Mon Feb 19, 2018 6:55 am
Forum: Printing Settings
Topic: Cannot get a good print
Replies: 9
Views: 191

Re: Cannot get a good print

1) I've found the best settings that work for me with the Raise3d premium PLA (R3DPPLA) are a nozzle of 210 deg. and a bed of 70 deg.. These are the only settings I change on the V2 hotend PLA setting in ideaMaker. When I use these settings with the R3D Prem. PLA I have no issues with prints coming...
by kazaar13
Mon Feb 12, 2018 1:53 pm
Forum: Printing Settings
Topic: Cannot get a good print
Replies: 9
Views: 191

Re: Cannot get a good print

I usually let the print stay for awhile before trying to get it off the plate. I have tried between immediate at completion through an hour or two. It just seems like the prints end up getting glued to the bed and are very difficult to pry off. 1. I believe the GAP is good. I read the instructions a...
by kazaar13
Sun Feb 11, 2018 10:35 pm
Forum: Printing Settings
Topic: Cannot get a good print
Replies: 9
Views: 191

Cannot get a good print

I am new to the 3d printing world as a user. I have been reading up on it for a long time. I just recently took the plunge and bought the Raise 3d N2 printer. This was so much larger in size than expected when it showed up. I validated my Z axis using the measure tool and it is at the correct height...

Go to advanced search