Search found 7 matches

by Nishanth NL
Thu Jun 01, 2017 4:02 pm
Forum: Printing Settings
Topic: PolyFlex & Nylon
Replies: 11
Views: 458

Re: PolyFlex & Nylon

For the split of Nylon, please make sure that you have turn off the cooling fan or block the downward cooling air to preserve high temperature for it. For PolyFlex the material is not extruding - Checked nozzle for clog (its clean and extrudes PLA and all fine!) - Increased temperature but the forc...
by Nishanth NL
Mon May 29, 2017 12:43 pm
Forum: Printing Settings
Topic: PolyFlex & Nylon
Replies: 11
Views: 458

PolyFlex & Nylon

Hey Guys, Tried printing with PolyFlex & Nylon and its become a nightmare for me! Reasons : PolyFlex - - Unable to load even after cleaning the nozzle using the tools provided by R3D. - The filament is too flexible that the gear is skipping. Nylon - - Printing the layer is hard! (Used ABS settin...
by Nishanth NL
Thu May 18, 2017 2:09 pm
Forum: Printing Settings
Topic: 0.2 nozzle settings
Replies: 9
Views: 526

Re: 0.2 nozzle settings

India
by Nishanth NL
Tue May 16, 2017 12:35 pm
Forum: Printing Settings
Topic: 0.2 nozzle settings
Replies: 9
Views: 526

Re: 0.2 nozzle settings

Set both nozzle diameter in printer settings and extrusion width in advanced settings from 0.4mm to be 0.2mm. Use No raft since the default Raft was designed for 0.4mm nozzle. Edit the first layer height to be the same as other layers. Or the 0.3 is too big for 0.2mm nozzle. Slow down the printing ...
by Nishanth NL
Mon May 15, 2017 9:13 am
Forum: Printing Settings
Topic: 0.2 nozzle settings
Replies: 9
Views: 526

Re: 0.2 nozzle settings

unless I made a mistake, the volume from a 400um nozzzle is 4x that of a 200um nozzle for the same extrusion rate! This should be handled by ideamaker under the printer settings BUT i suspect that you will need to print much slower, so since default is 50mm/sec, Id start with 10mm/sec and do a bunc...
by Nishanth NL
Mon May 15, 2017 9:13 am
Forum: Printing Settings
Topic: 0.2 nozzle settings
Replies: 9
Views: 526

Re: 0.2 nozzle settings

Set both nozzle diameter in printer settings and extrusion width in advanced settings from 0.4mm to be 0.2mm. Use No raft since the default Raft was designed for 0.4mm nozzle. Edit the first layer height to be the same as other layers. Or the 0.3 is too big for 0.2mm nozzle. Slow down the printing ...
by Nishanth NL
Sat May 13, 2017 12:33 pm
Forum: Printing Settings
Topic: 0.2 nozzle settings
Replies: 9
Views: 526

0.2 nozzle settings

Can u suggest the printer settings for 0.2 nozzle ?Materials that I use is PLA and ABS. THANK YOU

Go to advanced search