Search found 4 matches

by Gowfster
Sun Dec 31, 2017 11:23 pm
Forum: General
Topic: ABS Printing
Replies: 23
Views: 2034

Re: ABS Printing

I’m a noob to this, just got my N2Plus a week ago... but my ABS printing has been no problem. I use the standard profile in the slicer that came with the printer, use the Raise3d premium filament, have top on and doors closed, I use purple glue stick on the stock bed. The bed adhesion is higher than...
by Gowfster
Sat Dec 23, 2017 4:30 am
Forum: General
Topic: New owner: First impressions
Replies: 5
Views: 835

Re: New owner: First impressions

Today marked the arrival of my N2Plus! Some of my observations from the setup: - call a friend if you have to lift it at all, it’s not that it’s terribly heavy but awkward large and heavy so bad idea to lift it yourself - instructions to set it up and start using it were, well, terrible - for exampl...
by Gowfster
Wed Dec 06, 2017 12:43 am
Forum: Feature requests, ideas, wishes
Topic: IdeaMaker feature requests
Replies: 44
Views: 4495

Re: IdeaMaker feature requests

Add Ideamaker option for Support structure that is thin layer of pva at the model boundary then standard model filament from there down to build plate. Saves money by using small amount of pva
by Gowfster
Sat Dec 02, 2017 1:14 pm
Forum: General
Topic: Feedback on N2 plus dual
Replies: 18
Views: 3956

Re: Feedback on N2 plus dual

This is good information as I make decision on pending purchase. It does leave me with a big question, however... when is the next version going to be available as I think it could be worth waiting... based on this forum it would seem imminent and if I’m not in big hurry.....

Go to advanced search