Search found 5 matches

by squashbox
Sat Jul 22, 2017 12:50 pm
Forum: Hardware
Topic: Left Extruder Temperature Variance
Replies: 4
Views: 146

Re: Left Extruder Temperature Variance

Thanks Jetguy for the clarification, suspected that it was within tolerance just wanted to make sure. I've been thinking about insulating my heater blocks so I guess this is all the nudge i need to do it. Didn't know the new LCD firmware allows for new PID settings that's very cool! Will check again...
by squashbox
Sat Jul 22, 2017 8:31 am
Forum: Hardware
Topic: Left Extruder Temperature Variance
Replies: 4
Views: 146

Left Extruder Temperature Variance

Hey, Whilst printing I have noticed my left extruder jumps between +/- 1c of its target temperature. It does this every 20 - 30 seconds and I believe is causing some z ribbing. Any thoughts on some causes or remedies? It did not start after any hardware changes which is why I'm at a bit of a loss.. ...
by squashbox
Wed Mar 22, 2017 11:50 am
Forum: Hardware
Topic: Adjust Belt Alignment
Replies: 9
Views: 866

Re: Adjust Belt Alignment

lami3d + walshg thanks for the help, got it all aligned and a cheeky double check on the old bed level last night. All working a treat!

Cheers!
by squashbox
Mon Mar 20, 2017 9:20 am
Forum: Hardware
Topic: Adjust Belt Alignment
Replies: 9
Views: 866

Re: Adjust Belt Alignment

Thanks Walshg much appreciated.. guess thats my monday evening sorted!
by squashbox
Sun Mar 19, 2017 6:40 pm
Forum: Hardware
Topic: Adjust Belt Alignment
Replies: 9
Views: 866

Adjust Belt Alignment

Hey,

Was wondering if anyone has any tips / instructions on adjusting the belt alignment? My Y Axis is off and I cant seem to find an information other than the x/y checklist pdf.

Thanks!

Go to advanced search