Search found 1742 matches
- Tue Apr 25, 2017 10:57 am
- Forum: General
- Topic: N2 plus not a great experience before even printing
- Replies: 21
- Views: 794
I have contacted them. Still waiting on a solution. :x Here are the photos. This is the condition of my expensive printer when I unpacked it. 5B9519CB-5185-4A7A-8C47-77035BF607B3.JPG 198FDB49-C6C8-49FD-B1F3-5E83DB8FB713.JPG D7A73A4F-9610-4B05-BAC1-467B32762D7F.JPG 81F0204B-795F-4DDE-96B7-77EB6AA2F0...
- Tue Apr 25, 2017 5:38 am
- Forum: Hardware
- Topic: Where is the best place to put the two build plate clips
- Replies: 2
- Views: 31
If you want to print a rectangle almost reach to 300mm with dual-extruder installed, the only possible place for clips is back side. The size is build plate is 332 (X) *340 (Y) mm. The distance between two nozzles is 25mm. That means if you start a print from the origin (0,0) point, then left nozzle...
We are so sorry about the troubles brought to your side. The reason why we set so many screws under heated bed is due to we find that the levelness of heated bed is very hard to control. So that we increase the screws quantity from 9 to 13 to have more points to adjust the height of the heated bed. ...
- Mon Apr 24, 2017 8:36 am
- Forum: General
- Topic: motors say disabled but carrage wont move
- Replies: 11
- Views: 368
That icon is for disabling all the five motors. If you enable one of them after that, the other four will be still at disabled state. For example, after all the five motors disabled, then you use screen to move Z for 1mm. Then Z is locked again. But X Y and two extruders' are still free. In very ear...
- Mon Apr 24, 2017 8:30 am
- Forum: Printing Settings
- Topic: Make raft with 0.2 nozzle､ABS Filament
- Replies: 4
- Views: 58
0.2mm's model needs really slow speed. If we want to print Raft with 0.2mm's nozzle, we will slow down to speed to about 10-15mm/s. But we barely use Raft for 0.2mm nozzle's print, based on our tests, Raft will be hard to peel off with 0.2 nozzle.
- Mon Apr 24, 2017 6:09 am
- Forum: Feature requests, ideas, wishes
- Topic: Printer hardware / firmware / touchscreen feature requests
- Replies: 5
- Views: 300
7 has been already added in screen firmware. There is a tab called dash board which you can check the successful files you have printed and how much time each one takes and how long in total.